1088-32 bally

[my240]

how do you get the reel assembly past the pin on right side when trying to slide it out. no screw head on pin to remove it. hate to break something trying to lift it over it. this is a machine called quarters.
thanks

[Jon]

Can you post a picture of this pen

[my240]

sorry pics won't go thru. fatal error occurred. I will try later.  got the handle to pull but now reels try but won't spin. I can pull the reel section about 1/8 inch and it seems caught on something. Was going to clean it up. Yesterday my post showed a pin with nylon head I found laying in bottom. May be the problem also.

[Jon]

The fatal error is probably the picture is too big drop your quality down to a lower resolution and the picture should go through just don't drop down so low I can't download them and blow them up
Do you still think it's stuck on a pin if so show that picture

[my240]

I'll try that but same size sent yesterday, Is the reel section just suppose to slide out after flipping up the stops. Maybe i'm not pulling hard enough.

[Jon]

Once you lift up the arms on each side it should pull down out easily unless there is some corrosion on the plugs on the back I have pulled the arms down and had to use crowbars to get the real machine to pull out

[my240]

pic

[my240]

machine pic. hopper started a bit ago but no reels turning.