New Life Games LLC
**Reel Slots** Gaming Machines => IGT S2000 and Vision Games => Topic started by: foster on May 29, 2014, 04:42:02 PM
-
Removal:
Remove the 2 screws underneath the metal bracket that attach bezel bottom to bracket
Open printer head to access the upper tabs. Failure to release the tabs will snap them off the bezel when you try to pull the bezel free.
Work bezel loose from front of printer
Disconnect front harness from printer
Remove 4 screws holding metal plate to printer
Install:
Secure metal plate with 4 screws
Open printer head
Connect bezel harness to front of printer
Position bezel on printer working the upper tabs into the holes in the metal plate.
Secure bottom of bezel with 2 screws.
I posted this because someone accidentally broke a bezel trying to get it off a Gen2 Printer (it was not me)
-
Thank you for the information.
I am installing a Gen2 Universal Printer setup for netplex into a 17" round top Igt Lucky Larry Lobstermania that doesn't have one. I have been looking for a manual or information with pictures that will help me to know where the connections go. It has a curly cable setup with a three wire and a fourteen wire connectors, and USB end. I have not seen any place to plug in a USB plug. I have contacted the person that sold me the brackets, bezel, and a 10 wire harness. He told me that he needs to find and send me a 14 wire harness for it, and the bezel with the smaller 3 wire plug. The one he sent has a connector that is twice as large and only has 2 wires, while the bezel it has currently has a smaller 3 wire connector for the printer.
I hope someone has a manual that can help me install this correctly.