New Life Games LLC
**Reel Slots** Gaming Machines => Bally Electromechanical => Topic started by: Phan000 on December 19, 2021, 10:34:50 AM
-
Fixing this machine for a friend.
Reel stops would not engage. Upon inspect, clock gears were shot.
Replaced clock and stops work fairly well now-
However, first reel will intermittently pull back very briefly, or not at all when handle is pulled. I cleaned and lubed everything in that area already.
-
the most common problem is the kick is happening a little too quickly - before the reel 1 index arm has latched. Reel 1 immediately indexes instead of spinning for a while.
see if moving the stop bracket on the right rear/bottom of the reel mech a little toward the front helps.
-
What I had was maybe uncommon but you never know... my topic discusses most of the common problems too:
http://newlifegames.com/nlg/index.php?topic=28167.msg148454#msg148454 (http://newlifegames.com/nlg/index.php?topic=28167.msg148454#msg148454)
-
Thanks for the suggestions. That last thread ^ looked like you went deep down the rabbit hole chasing a broken pin!
-
Just out of curiosity is it a $1 criss cross machine?
-
It was a quarter version. Lubed and adjusted a bit and the problem was pretty much nonexistent.