New Life Games LLC
**Reel Slots** Gaming Machines => WMS Reel Games => Topic started by: Nepa Coin Op on March 11, 2021, 12:26:08 PM
-
Going in circles here, need some help...... I keep getting those 2 errors one or the other...... game was working fine then the 24v supply went, changed that it was ok for one boot up, changed the spn board on the side wall, changed the reel controller board, checked all connections, cleared and rebooted game still giving them .... I’m at a loss here .... any help is greatly appreciated
Thanks
-
There's an issue with your spn bus. Maybe backplane is bad? Are all the voltage lights on the backplane lit up green? The SPN cable goes from the backplane to the the reel controller under the reels, then it branches out to the LED SPN connections, and if you have animator button panel there is a connection that goes to that as well. Also the reel controller needs power.
-
I’m wondering if when this 24 power sup shit the bed if it didn’t jazz up other stuff, I changed all the cat cables, changed the reel controller on the roof changed the spn controller on the wall, only thing left is the display,backplane spn board in the door and mpu ... I guess I’ll keep swapping till I get it .
-
There's an issue with your spn bus. Maybe backplane is bad? Are all the voltage lights on the backplane lit up green? The SPN cable goes from the backplane to the the reel controller under the reels, then it branches out to the LED SPN connections, and if you have animator button panel there is a connection that goes to that as well. Also the reel controller needs power.
All voltages are fine, I may have the cats in the wrong positions at this point would you happen to have the layout of which goes where ?
-
Verified all cats are good with a cable tester .... not much left now but mpu and BP
-
Done !!! Bad backplane
-
Good find.
Sucks when that happens though.
Curtis ash100
-
Good find.
Sucks when that happens though.
Curtis ash100
I know it’s solid now