New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => Konami Games => Topic started by: Melissarmdlm on May 01, 2022, 10:02:04 AM
-
So I finally acquired a KP3 ram clear card.
I naively thought I could clear a KP3 and select standard validation to get the podium to print tickets. Too bad it's not working.
So with selexion software and volcanic rock fire installed tested and playing fine. I was hoping to figure out my cashout problems. Printer tested and working from diagnostic menu. Perhaps it's an eprom boot chip thing?
Validation is setup as:
Serial number and asset set
Ch 1, Adress 1, SAS, no lockup.
std validation
Machine control and TITO on Ch 1
Any ideas, without just brute force trying settings for ticket printing?
-
That should do it.. Check the cable?
Activity lights? The machine will keep spitting out its sas id until it gets a proper response.
-
you have machine control, receive time, tito, legacy bonusing, eft/aft on the same channel as your tito board?
Also, remote handpay and handpay queue enabled?
I am fairly certain validate mode needs to be set to "system" not standard. ticket out to "cashout", handpay receipt "none". cashless transfer to "EFT", EFT/AFT partial transfer set to "full transfer only"
-
Yeah, system.
Also set the SAS ID to something other than 0 (K2V defaults to 0). ID 0 disables "SAS" according to the protocol spec.