New Life Games LLC
**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: clizifer on March 19, 2021, 11:59:00 AM
-
Just picked up a Bally S6000 the other day and it had an 8100 error code which i figured out was the batter. I replaced the battery and now when I turn it on it comes up with an 83F0 error. Do I require the clear chips to reset this error? If so is there anyone on here selling clear chips and willing to ship to Canada? Any help is appreciated. Thanks
-
What U28 and U43 mains are on your board now? If you have leave in clear chips you don't need to buy any. If not you will need to purchase a set of clear chips. Send a message to member RB for chips
-
They have the numbers S6M1000C007 and S6M4000C0007 on them. I doubt they are the right chips, I will message about getting some clear chips and go from there, thanks
-
a set of clear chips should do it
-
Awesome, thanks
-
ok so a little update on this. i received my clear chips finally and was able to do the complete clear. the display went from CH C to CL C, then i turned it off and swapped the chips back to the original one and when i put the board back in im still getting the 83F0 error. did i miss any steps or what did i do wrong?
-
can anyone help me with this error or am i on my own with this one?
the battery is brand new, the dip switch 8 is off, ive tried doing the clear several time and i still get the same error when i start it up
id really like to fix this machine and play it, otherwise ill have to just sell it off as is
somebody help me please
-
If you purchased the Leave In Mains from RB, there's no need to pull them out after the clear.
You stated that you cleared the machine and then pulled the EPROMS and put back in the originals. That may be where the hang up is. Just leave them in the machine.
The only thing required is to set Switch 8 on DS1 back to off after the clear.
Machihe should reboot into "set the Date" after the Reels do their calibration.
Set the date or press Cashout to exit. Close the door and you should be good to go.
Curtis ash100
-
If you purchased the Leave In Mains from RB, there's no need to pull them out after the clear.
You stated that you cleared the machine and then pulled the EPROMS and put back in the originals. That may be where the hang up is. Just leave them in the machine.
The only thing required is to set Switch 8 on DS1 back to off after the clear.
Machihe should reboot into "set the Date" after the Reels do their calibration.
Set the date or press Cashout to exit. Close the door and you should be good to go.
Curtis ash100
hey thanks for the reply. i dont think the chips i got were the leave in ones they are just the safe ram clears. either way i did give it a try and it seems to work! thanks for the help. on my first pull i ended up getting the any 3 7's and won 100 coins!!
-
I have a Bally 6000 Monte Carlo 3 reel slot. I have different error codes when tring to fiux it. I installed a new battery on the board. I have the 26 & 43 Clear Chips and I can not get it to clear. I’ve gone through the push the button 11 times and nothing. Right now it has 83F0 a error. but all the buttons are flashing
Help
-
Which clear chips do you have? Leave in clear chips or the removeable type? Leave in clear chips may not work with Monte Carlo. Leave in clear chips use switch #8 on DS1 and the removeable do not. Which do you have?
-
I have the removable chip U28 & U43 The Switch on DS1 #8 is in the on position, I have not moved any dip switches.