New Life Games LLC

**Reel Slots** Gaming Machines => IGT S2000 and Vision Games => Topic started by: millionaire2k on August 23, 2021, 01:54:30 PM

Title: $ coin head install question
Post by: millionaire2k on August 23, 2021, 01:54:30 PM

Im installing a $ coin head on my .50 cent s2000.  The bracket the CC attaches to lines up with the middle screw in the head.  However the far hole in the bracket does not match with the 2nd screw hole.  There is a hole to the far side of the bracket but it does not align.

Here is a pic of the part that does not align except for the middle hole as the example in the diagram shows.

https://imgur.com/jzDfz28

(https://imgur.com/jzDfz28)

Title: Re: $ coin head install question
Post by: dailey on August 23, 2021, 02:35:31 PM

The coin-in assembly drawing you show is for large coins.  .50 cents is considered a small coin. The small coin assembly is for coins up to 1.457" diameter.   The .50 cent coin is about 1.207" diameter.

An example of a large coin is the Eisenhower dollar which is 1.500" diameter.

Title: Re: $ coin head install question
Post by: millionaire2k on August 23, 2021, 03:09:23 PM

The coin change Manuel gave a list of all things I have to change, it says noting about needing a larger assembly.

I changed everything except I didn't add the coin guide.

https://imgur.com/zyvNEix

Title: Re: $ coin head install question
Post by: dailey on August 23, 2021, 04:28:28 PM

I guess I misunderstood.  Are you saying you are changing from 50-cents to $1.00 coin ?

Title: Re: $ coin head install question
Post by: millionaire2k on August 23, 2021, 05:56:41 PM

I fixed the issue.  I had to slide the entire assembly and coin Shute over to the left about an inch.  Everything then lined up as expected.

Thanks to all who helped.