New Life Games LLC
**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: dnapappas on May 05, 2017, 06:21:22 AM
-
I purchased this machine from someone that removed the coin hopper and installed a TITO board. He gave me the hopper with it. I want to put it back in the machine and have it working again. Besides installing the TITO board and the 2 jumpers in the hopper plug, I don't know what else was changed to make it work without the hopper. Can someone help me with this? I know I have to remove the jumpers and relocate the TITO board, but what else do I need to do to get it working again? Thank you,
Dave
-
More Pictures, The hopper does work, It was just removed because the guy didn't want to use it.
-
You have to reprogram machine.
-
Here's what settings are. If you do not understand you can contact me.
-
I'm new to this machine. I have no idea what the PDF document is telling me. I never programmed a machine like this one, and I don't know where to start.
-
If you need help I PM'ed you a message as to where I am.
-
I should be going thru your area within the next month to work on machines. If you PM me your name, address & phone # I can give you a call when I'll be in area.
Ford
-
dnapappas, Did you fall off the edge of the earth? DID YOU GET MACHINE WORKING?Ford
-
Sorry guys, I just got really busy with work and stuff around the house I got side tracked. I'm still trying to get instruction on how to reprogram the machine. I want to get the hopper working. If someone could tell me how to begin reprogramming the machine that would be great. Thanks,
Dave
-
Do you know what # chips are in the U28 & U43 spot on MPU? Some you have to have a set of chips to clear. If it is a machine that came from me down the road it should have chips that you don't have to change. If your not sure take a picture of board.
-
I did get a set of chips to clear. One says U43 Clear and the other says U28 Clear. I also noticed on the front of the board, the is a toggle switch marked coin mech.
-
LEAVE THE COIN MECH SWITCH UP. What you have to do is a complete clear use the settings I posted. You should have a manual so you know how to do it. Send me a private message with your address & if not to far out of my way I can stop in on 6/3/17. Not one of machines I sold, Mine have chips that you don't have to switch out.
Ford
-
I know somewhere on this site it's posted how to do a complete clear.
-
Ok, I do have a manual for this machine. The guy I purchased it from e-mailed it to me after I picked it up from him but then I forgot all about it. I just checked back in my email and it was there.
-
Good. Go to pages 2-12,2-13, & 2-14, etc. That should give you how to do a COMPLETE CLEAR. Be careful with legs on chips & make sure you put them in with the notch in proper direction.
-
Ok, not sure if I will get to it tonight, but when I do, I will let you know what happens. Thanks for your help,
Dave
-
That's what this site is about, helping each other.
Ford
-
Take your time. If you screw up you have to clear & start over.
-
If you bring your machine to my place I'll get it working for you NO COST UNLESS IT TAKES PARTS.
Ford