New Life Games LLC
**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: meatman1010 on March 29, 2017, 09:08:07 PM
-
hi, on my s 6000, I put a new battery in and did a full clear with the 28 and 43. all the lights just keep on blinking . nothing else happens. tested batt. on board and is good can some tell me what im doing wrong. thank you.
-
so, you're still getting an 83F on bootup?
Is J12 jumper enabled/on? The battery will be disabled until there's a jumper there.
When I picked mine up, the jumper (posts) were broken straight off the board, so I didn't even realize one was supposed to go there, and I needed to fix that before I could do anything else...
If the jumper is on, but still getting 83F, you may want to check with a multimeter to make sure the battery is actually flowing through that jumper...
-
If the RAM chips are getting battery power you could try swapping them with each other then clearing again.
Also check for bent pins on U28 and U43 when you re-inserted the game chips.
Also make sure DSW1 switch #8 is off after clearing.
-
Hi where is the dsw1 #8 switch located. I don't even get a 83 F soon as I turn it on all the lights in front flash even when I try to do a clear ..thank you
-
Without that switch being on you won't get a full clear.
If the front of the tray is facing you the 8 position DIP switch is on the left half way up the board.
-
Hi, got the 6000 going. It was the j 12 posts . They were slightly green from corrosion. You had to look really close to see it. Used small file and had to dig jumper a bit. Know I have to get bill validator going the front light is on. It even stays on when the door opens?.. what might it be ...thank alot guys....