New Life Games LLC
**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: puckhead on May 01, 2017, 02:51:26 PM
-
i had a working e2000 that i havent used in a few weeks. now its not working. battery is a new lithium with a diode, right now its at 3.03 volts. im getting immediate error code 1....6 . sometimes the 1 will change to a 2, then back to 1. after a few seconds the 1st digit may just flicker. i reseated the rom chips and checked my voltages. 4.9, 7.2, 9.8 . no cracked headers or burned connectors.
any ideas?
thanks
-
pulled the mpu, the socket for u30 had a little battery corrosion. replaced the socket, and ringed it out, its good. now on start up i get
.....1 . hopefully thats better? the cable from the mpu to the IO card, the bottom left pin broke off. i will get a new end put on the cable, but not until i get it to boot properly. would that one pin affect the boot?
thanks
-
Yes, one pin can ruin your day.
-
sounds like the ribbon cable is your problem..
-
hopefully solved. i had the ribbon cable repaired with a new connector at an electronic supplier. installed it, same old thing,
1....6 in the display . started pushing the reset like a maniac, and i noticed the display digits started to change. next thing i know its working. ive turned it on and off multiple times, so far , so good,