New Life Games LLC
**Reel Slots** Gaming Machines => IGT S2000 and Vision Games => Topic started by: foster on February 21, 2014, 08:11:27 PM
-
This was originally posted by "Stayouttadabunker" and suggestions by other NLG members.
With editing for clarity and simplicity by foster
You will need to acquire some wire and a few connectors to make this modification
Also be familiar with crimping connectors or wire splicing (soldering is recommended but not necessary)
Parts needed:
2 pin male housing with female connectors Molex Micro-Fit Jr They are white
2 female quick connects 1/4" size
if you do not plan ever using optics again the connector attached to either optic will be the only other connector needed.
22-24 gauge insulated hook up wire
FIRST turn off machine, otherwise you might let out the magic smoke out of the electronic parts.
Remove reel one to gain access to the optic harness coming from the door
It connects to the machines harness behind reel one.
You can unplug door side of the optic harness.
If you have a printer next to reel 3 you may want to get it out of the way as well.
Remove switch bracket from machine, no need to remove switch from bracket.
The spare pole of the cherry switch has nothing connected to it.
Connect red wire with white stripe in the machine side harness to Normally Open contact of the spare pole to cherry switch that is in the machine.
Connect green wire machines cabinet optic harness to the common terminal on the spare pole
Re install every thing but the cherry switch you may have to move a wire to get it work if you connected the wires incorrectly.
Power up the machine it should show no tilts except door open
Push in the cherry switch, machine should go into ready for play mode.
If switch is wired correctly carefully install it in place otherwise recheck your wiring and switch connections.