New Life Games LLC
TITO - Ticket in Ticket Out, Slot Toppers, Stands and Add-on Accessories => Slot Toppers => Topic started by: steven1969 on June 08, 2016, 03:50:32 AM
-
I HAVE A IGT TRIPLE DIAMONDS S2000
I WANT TO HOOK UP THE TOPPER ON THID MACHINE BUT THIS DEFERENT FROM OTHERS
CAN SOME SHOW ME HOW WOULD THIS GET HOOKED UP
-
You should have a 4 pin plug from topper. It goes into the distribution board you have pictured. Only problem is you need a harness to send power to dist. board. You will see power in and out 1,2,3,4.
-
If you have the other machines working - can't you just measure the voltage in the harness and put in a generic power supply ?
-
If you have the other machines working - can't you just measure the voltage in the harness and put in a generic power supply ?
He would need Two power supplies ... Back light 24 VDC, and Ring would be 12 VDC.
-
You can buy power supplies that have multiple voltages out.
I picked up a couple off of aliexpress that have 24v 12v 9v 5v for .$9.99
I use them with my Jamma boards
They are not wall wart style, more of the screw terminal industrial look.
-
You can buy power supplies that have multiple voltages out.
I picked up a couple off of aliexpress that have 24v 12v 9v 5v for .$9.99
I use them with my Jamma boards
They are not wall wart style, more of the screw terminal industrial look.
$10 for a multi voltage supply ... That is awesome!
-
I picked up 3. First one blew up in the first 5 min. The rest were good. You get what you pay for.
-
In order to use your machine as the power supply, you will need a harness. Right now you have a harness on the right side of your cabinet that plugs into the sound board on the right back wall. Orange and orange/black stripe are 24vdc. Red and Red/black stripe are 12vdc. I think Idesign can make one for you. Now all this is useless if the 4 pin square plug is missing from polygon topper.
-
Does anyone have instructions on making the wiring harness?
I'm guessing the wire harness would consist of running an additional wire OUT of each of the 4 terminal pins. These additional wires would then go to a connector that the topper would plug into? Basically, you'd be daisy chaining the topper into the circuit.
Is this correct?
-
See this post ....member Harvs made one at one time
http://newlifegames.com/nlg/index.php?topic=3748.0 (http://newlifegames.com/nlg/index.php?topic=3748.0)
-
Thanks,
I reached out to him...hopefully he'll get back w/ me soon.
-
IDesign makes them too.