New Life Games LLC

**Reel Slots** Gaming Machines => IGT S and S-plus Reel Games => Topic started by: tcarp on October 06, 2017, 08:43:57 PM

Title: swapping out mpu boards in S plus
Post by: tcarp on October 06, 2017, 08:43:57 PM

We have two S plus machines a Double Diamond Deluxe and a Triple double Diamond both have SP731. Having problems getting the Triple Double machine working, so we put the board from the Double Diamond in the TDD to see if it would work. Now when we put the board back into the DD will it effect anything? Will we need to clear or reset anything? Please advise.

Title: Re: swapping out mpu boards in S plus
Post by: Ken on October 06, 2017, 09:17:39 PM

It should fire back up.

Title: Re: swapping out mpu boards in S plus
Post by: tcarp on October 07, 2017, 08:39:46 PM

Well after installing the board back in what was the working machine it is showing code "3100" and then changes to "1" then back to 3100 and so on. Could it be in a test mode or accounting ? Could someone please walk me thru how to fix this. or what to check. Oh and the door optics were just replaced, could that have anything to do with it?

Title: Re: swapping out mpu boards in S plus
Post by: knagl on October 07, 2017, 09:48:43 PM

Common IGT S+ error codes and their resolutions are found here:

http://www.newlifegames.net/igterrors/ (http://www.newlifegames.net/igterrors/)

If opening and closing the door doesn't resolve the problem, are you positive that the new door optics are installed correctly?  Stupidly the emitter and receiver have the same plug, so it's possible to install them backwards by mistake.

Title: Re: swapping out mpu boards in S plus
Post by: Ken on October 08, 2017, 06:41:39 AM

For the door optics .. white wire on cabinet side. Red wire on door side.

Title: Re: swapping out mpu boards in S plus
Post by: tcarp on October 09, 2017, 12:56:10 PM

Thanks for all of your help! It was the door optics, got a new set and its up and running. You guys are great.