New Life Games LLC

Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: BigEd on December 19, 2020, 08:00:54 AM

Title: Bally S6000 Bill Validator Won't Activate
Post by: BigEd on December 19, 2020, 08:00:54 AM

Have a Bally S6000 Black and White machine with no coin op, just bill validator.  I bought it 2nd, 3rd, hand, for my home.  Unfortunately, while the bill validator has power and I can see the red lights on the inside, it doesn't activate at all when a ticket or bill is installed.  Nothing is bound in the mechanism it just doesn't operate.  I've replaced the MPU just in case, but that didn't make a difference.  I've cleared the system many times and get to the point where the machine is simply looking to accept credits, so it's ready to go.  I'm thinking I don't the the correct dip settings?  I'm not sure, but i'm out of ideas.


Any help would be greatly appreciated.  Thank you!

Title: Re: Bally S6000 Bill Validator Won't Activate
Post by: Sunrise Side on December 22, 2020, 07:30:00 AM

Do you have a MEI or WBA  BV ? 

Dip Switch pack 2

Switches 5 & 6

WBA  = On Off
MEI MARS = Off Off

Title: Re: Bally S6000 Bill Validator Won't Activate
Post by: pbwizard25 on December 22, 2020, 09:14:33 AM

Coin mech switch on the front of mpu must also be in the up position. If your dip settings are not correct you must clear again after setting them.