New Life Games LLC
**Reel Slots** Gaming Machines => Bally Electromechanical => Topic started by: DrewMcAvon on December 21, 2020, 02:38:16 PM
-
I am working on getting a 3 wheel, nickel Bally EM1008 working. During trouble shooting I found that the bottom solenoid on the hopper was bad and there was a wire loose. See picture. I am not sure where that wire goes. I have a feeling it goes where the tape is located (I put the tape there). It is a brown and white wire. Any help is appreciated.
-
schematic for an 1008-3 is on http://bingo.cdyn.com/slots/ (http://bingo.cdyn.com/slots/) - see delay relay circuit around schem D2
based on that, yup, the 47 ohm resistor goes on the spot you indicated. There should also be a grey wire (90-1) there.
-
Thank you very much. I will connect once I get the replacement solenoid. The one they sent was a dud. I will also check out the Schematic at the link you sent.
-
I reconnected wire and installed new coil. Machine works after a few more wires and 1 more coil replaced. thank you for your help.