New Life Games LLC
Progressive Controllers and Displays => Mikohn Progressive Systems => Topic started by: rharding on March 19, 2014, 09:24:50 PM
-
Newbie here, been lurking and learning a lot from this site. I am needing the PSP software to program a Mikohn ChamII stand alone unit. Can anyone advise where to locate or provide a link.
Thanks,
-
I have both psp 2.01 and 3.01
can send via e-mail after pm your e-mail address
-
Thank you very much, just pm'd you.
-
Sending this via has been an exercise of patience
Many E-mail systems are blocking EXE files, because they might contain a virus
they should scan and warn the recipient.
It is our responsibility to be careful who sends us files, we should also be scanning anything we receive or download.
I had to upload it to a file sharing site with password protection
-
A very big thank you to Foster for sticking to this request and seeing it through. :applause:
-
Just change the file name to .EEE and tell the user he needs to change it back to use.
Much easier than the pain you went through. Thanks Foster.
Rich
-
I tried that, they actually scan the file, and determine it is a exe file renamed.
-
Hello everyone and thank you to all who respond.
We are also looking for the Mikohn PSP Software (either version 2 or 3 .. not sure which will work) to program a standalone (dual sided) sign. This was part of a Casino progressive jackpot display and we are modifying it to display messages that we can program. Each display has its own CHAM II board with DB9 interface. We are planning on using a PC (old Dell laptop with a DB9 interface) to direct program the displays (if at all possible).
I have been reading for some time on the topic and have loads of information on the programming, just no software to begin. I have downloaded the PSP Ver. 2.0 manual from RudysDeals.com (and thank you to this site for that lead).
Thank you again to anyone that can assist.
Mike
Henderson, KY
-
Check the download section on this site in the mikhon area .
-
I went into the NLG File System area and got this message:
An Error Has Occurred!
You are not allowed to view the Downloads
Can anyone help with that or are the 'downloads' in a different area?
Thank you again for all your assistance.
Mike
-
Mike,
I believe the new site requires you to be a contributing member to access download area.
Really a small price for the amount of information you get from this site.
-
I tried that, they actually scan the file, and determine it is a exe file renamed.
-
Is there an access to the manual, PSP program and cable for the Mikohn Con 2 I Super Controller
V.4.01.
-
Can anyone send me Mikohn Downloader software?
-
Also looking and not allowed to download yet.
-
Mikohn PSP software needed
-
I Mikohn PSP software needed
-
Mike,
I believe the new site requires you to be a contributing member to access download area.
Really a small price for the amount of information you get from this site.