New Life Games LLC

**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: trashman on February 09, 2018, 04:30:01 PM

Title: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: trashman on February 09, 2018, 04:30:01 PM

hi what safe ram clear should i do complete, full or partial, or do i even have to do that i have chips and manual to do job but it dosnt tell me thanks

Title: Re: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: Badbaud on February 09, 2018, 08:38:58 PM

Try the clear without the clear chips first.
Put the SRAM CLR jumper on both pins.
Hold in the test and pseudo coin buttons, make sure the coin mech switch is in the up position.
Leave the door open and turn on power.
Watch for a CHC then a CLC.
If you get CHP or CLP tap the reset while holding in the test and pseudo buttons.
After the clear leave the door open and let the reels do their bump seek.
When you see a 50 code on the door display remove the board and put the clear jumper on one pin  the game is ready to play.
If none of that works you may need clear chips.

Title: Re: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: trashman on February 10, 2018, 04:02:40 AM

hi what is the number on the board for the SRAM CLR jumper pins thanks

Title: Re: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: Badbaud on February 10, 2018, 07:40:48 AM

Facing the front of the board it would be the front right corner.
Attached is a form I tape to the top of a customer's board after fixing.

Title: Re: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: trashman on February 10, 2018, 09:02:10 AM

ok im going to give it a shot thanks

Title: Re: new bee to fixing bally slots. the 5500 battery was dead and now replaced.
Post by: trashman on February 11, 2018, 04:12:05 AM

That worked Thank You