New Life Games LLC
**Reel Slots** Gaming Machines => IGT S2000 and Vision Games => Topic started by: foster on March 17, 2014, 11:55:55 PM
-
The S2000 will tilt if anything gets disconnected or loose
When this happens start with the device that you are getting the error about and work back to the motherboard.
First try clearing the error by lifting and lowering the main door latch a few times.
Always do the following with the machine off just in case.
Gently push in the mpu with both hands because sometimes, it may not be fully seated
Make sure the 2 or 3 I/O cards are fully seated any harnesses connected to the handle end of them is fully connected.
You will have 1 Cabinet I/O and 1 or 2 Door I/O boards in a upright machine.
Check the connections to each display in the machine, VFD and 7 segment display
Check the 3 connections to the Bill Acceptor in an upright machine they are behind the Bill acceptor, near a light that gets very hot quickly so be careful
Check each connection to the motherboard just disconnect and reconnect it, do one at a time so you do not lose track of where a connection goes.
Pull the reels, behind them in a upright machine will be the 13/25V power supply (300 or so watts) there is a screw on the left side loosen it and disconnect and reconnect(push on it firmly) the power supply, tighten the screw do not over tighten.
Devices connected to Cabinet I/O
Physical meters
Hopper
Handle switch and solenoid
W-2G key switch aka second reset key
Bell
Back lit controller (cabinet I/O does not control it)
Devices Connected to Door I/O
All player button switches and lamps on the player deck
Coin coin comparator
Coin in optics
Coin solenoid controls coins going to hopper or into drop bucket in stand (overflow)
7 Segment 5-5-2 or 6-6-3 and multiple denomination touch pad (door i/o does not control it)
The following devices are Netplex and either directly connect to the motherboard or by a power dist board depending on your harness configuration in the lower cabinet.
Bill Acceptor has its own Netplex port (12 pin instead of 10 due to bill acceptor door switch)
Printer
VFD
When you get errors or tilts that are cleared by closing the door, you may have to raise and lower the latch multiple times to clear the errors, they get stacked and only one error will clear on each door closure.
Recommended spare parts:
MPU that matches your current mpu with matching chips
Door and cabinet I/O that matches your machine
If not done so already convert your player buttons to LED and if the Bill acceptor board on the door still uses the lamps get the LED version.
IF your S2000 is working correctly and you are not trying to do a game change or upgrade, leave it it alone. I can not stress this enough.