New Life Games LLC
**Reel Slots** Gaming Machines => IGT S2000 and Vision Games => Topic started by: Nepa Coin Op on May 20, 2023, 03:01:17 PM
-
Does anyone know the correct part no and location of the 2 cards on the door of an s2000 enhanced ?? I have one here none were in it and I am having trouble with lights and so on I believe I have the wrong ones in there
Thanks
-
Machine is a 5r9L
-
With the proper IO cards now in I am still getting coin in jam, board is clean with zero acid damage however at this point I’m at leaning toward the mpu being bad.
-
Coinless? Jumper installed?
-
Ron coinless, no hopper no mech, jumper in.
-
If you are sure your I/O cards are correct and good, I'd lean toward the MPU. If it is a 50X board post a picture of U67.
-
I have no control panel either all buttons are dead
-
What I/O cards are you using.
Should be 801 and 802.
Check for bent pins
-
801 and 802 or both 802 ??
-
801 and 802 or both 802 ??
If the standard button harness has the addressing jumpers (most 5 reel machines do) you can run an 802 in both slots if it does not you have to use an 801 im that slot. Senet devices are connected part in parallel and part in series so if any of them has a fault it can cause false errors