New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: gposing on August 23, 2015, 11:05:15 AM
-
i have a transport that will pull the bill in, pause then kick it back out. I have swapped the chip and head with a working unit, so I'm almost sure it must be transport. Any ideas on what could be causing this. I would like to get working so I have a spare one. Thanks
-
make sure credit limits are set right
-
Tried it with no credits in machine. It is like the unit reads it but not communicating with slot.
-
Have you checked the bill path for blockage, like another bill or something stuck in there? Also on some machines I think it won't accept any more bills if the credits already on the machine are near the hopper limit. Have you tried different bills, including a $1 ?
-
Could the dip switch position cause this?
-
I switched them all on then off again.
-
Tried it with no credits in machine. It is like the unit reads it but not communicating with slot.
sounds like credit limits are too low
-
I will double check them. Thanks
-
What bill are you trying, I don't think the wba11's will take all the colored US bills.
-
I pulled out the manual and can not figure out how to get the the 7<5> menu. I can get the 7 in the coins played by pressing the test button, but it will only allow me to change the hopper pay out. :banghead:
Gary
-
Sometimes you have to turn the reset key to advance through certain menus. Just a thought.