Bill Validators, Currency Acceptors and Printers > JCM DBV-45, DBV-145, and DBV-200 Bill Validators

DBV200 problem in S+

(1/1)

rjpohl:
I've shipped a guy a full DBV200 setup (everything including housing/power supply/head/transport/screws/etc) for a S .  I tried the bv head/transport in my test machine before shipping and it worked.  It seems to cycle and setup properly (I listened to it over the phone) and it's enabled (9-1).  It does not even attempt to pull a bill in.  Could this be a bad power supply even though it cycles and sets up?  I plan to ship him a power supply but thought I'd ask if anyone has any other thoughts (motherboard/cpu).
thanks
Bob

shortrackskater:
Has he checked the "standard" things:
Is the bill box seated?
Are all doors closed...optics aligned?
Check all wiring/plugs?
Is the unit seated properly with the latch down?

Buzz:
http://newlifegames.net/nlg/index.php?topic=4226.msg8620#msg8620
 
 
Bob  Look at reply 23
 
 
 

rjpohl:

--- Quote from: shortrackskater on December 18, 2014, 11:12:41 AM ---Has he checked the "standard" things:
Is the bill box seated? Yes
Are all doors closed...optics aligned? Yes, it accepts quartes and plays
Check all wiring/plugs? Yes
Is the unit seated properly with the latch down?  Yes

--- End quote ---

rjpohl:

--- Quote from: Buzz on December 18, 2014, 11:20:37 AM ---http://newlifegames.net/nlg/index.php?topic=4226.msg8620#msg8620
 
 
Bob  Look at reply 23

Thanks Buzz, question will the bv setup if pins aren't bent properly?
 
 
 

--- End quote ---

Navigation

[0] Message Index