New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: Sgadd on April 08, 2023, 08:49:37 PM
-
I can't enable my GEN2 Netplex printer in key configuration. I have a IGT S2000 using Key chip 45. I have the 8 pin connection made. Printer ready light is on. Printer will print a test page. When enable, the screen displays "Netplex auto config" and then goes to disable. The machine acts the same if I just unplug the printer and try to enable. The dip switches are all off except 2 which is on. Help is very appreciated. I have tried a different printer and cable with the same result. Please help.
-
Turn machine on while holding in the button on printer and it will print the firmware version.
-
Turn machine on while holding in the button on printer and it will print the firmware version.
Thanks for responding. Firmware: GNUSA5410 TKT-2.3
A label on the printer says that as well as PSA66ST2N
-
I have not found any info on that firmware version.