Bill Validators, Currency Acceptors and Printers > JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators

New $100 bills and WBA 12-13

(1/3) > >>

Brokenwizard:
I have a WBA12-13 (708bh) validator ID=003 USA V3.75 (This is what's written on it)
Question 1. Can I just replace the chip on the back so it will accept the new 100's and
2. If so anyone know where I can purchase the chip.
I know I can send the whole thing out to be updated but it would be simpler if I can just replace the chip.
Thanks in advance,
 
 
 
 
 

Ken:
Replacing the ID=003 USA V3.75 chip with a ID=003 USA V3.8(x) chip will get you the new 100.

foster:
The only thing is when you replace the EPROM you need to do a calibration on the head after chip is installed as recommended by JCM and just about everyone that has done it.

Brokenwizard:
Doesn't recalibrate mean cables and or software needed? I have computers but nothing else to facilitate a calibration.

CVslots:
We sell calibration papers for WBAs. They are a paper that is fed in and it "realigns" the head so that it reads bills properly. Often times, it is used as part of a tune-up.


Here's what the papers look like:


http://www.centralvalleyslots.com/jcm-wba-validator-paper.html

Navigation

[0] Message Index

[#] Next page