New Life Games LLC
**Reel Slots** Gaming Machines => Bally Alpha Reel Games => Topic started by: armyaviation on March 27, 2024, 10:26:38 AM
-
I have a bally alpha with the small screen n the center of the game. The screen and touch were working fine but over the winter and them being in the garage i noticed the small screen touch doesnt work now. I tried to get it into calibration mode but half the screen doesnt work and the bottom right corner is about in the center of the screen. is it lost or is there a way to fix it, thanks
-
Hi, Had a similar problem with my S9000. There is a metal plate protecting the wires on the door behind the lower monitor. The USB cable to this lower touch screen monitor bbehind this plate has a USB male and female connection. Loose connection was helped by slightly bending in the plug to create a much tighter connection. Seems to have cured the problem. The cover plate is held on by 2 screws. Hope this helps.
-
Re: cover plate on back side of door, it’s held on by ( 2) 5 mm (if I remember right nuts…. NOT screw. Sorry
-
my screen doesnt use a usb. i understand what you are getting at. does this pic help? are you referring to something somewhere else, thanks
-
There is a cover plate over some cables on the back of the door right behind and below the lower touch screen monito.
-
The picture shows where I found my loose usb connection. It is like an extension cable connected with a male and female usb cord that goes to the monitor.
-
You need to take the cover plate off to see where the cables were connected. At least that is where my problem was (a very loose and poor connection).
-
I think they are different but I will check thanks
-
I have the complete panel available, this came out of machines that were taken off the floor, supposedly working. I have no way to test it.
60.00 plus shipping
Jim