New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => IGT AVP (Including G20,G23) => Topic started by: The laneman on December 11, 2023, 08:11:31 PM
-
Im going to add a tito to my Igt SMLD and have a couple of questions....
My backplane looks like the one in the picture I attached.Will I need a rs232 daughter board to connect the tito to or is there somewhere on the backplane to connect it to?
If I need the daughter board where does it connect on the backplane?
-
Yes you will need one. J29 is comm 1. 26, 27 & 28 are comm 2, 3 & 4.
-
Thanks for the reply..
I had the wrong backplane picture.This is the one I have.
Its hard to see the numbers on the backplane when its in the machine.
Will the daughter board connect to one of the connectors I circled in the picture?
-
Yes that is correct.
-
Would the connector on the far left be com 1?
-
Laneman,
Aren't both photos you've posted the same board?
The 1st one you posted is only upside down?
I have the same board.
The leftmost header of four is [J139]
The other three 16-pin heaers are labeled as J140, J141 , and J142.
I do NOT know which one you'd plug in a Tito board to tho.
-
I changed both pictures to show the correct backplane Im running.
-
oh okay
I would guess that the J139 header would be the one to use.
If not, try another one.
Nothing would get hurt.
The connector you're plugging from has 16-pins?
Below is my board...same as yours.
I don't see a J29 on it tho?
The connectors start from J100 to J149 on this board.
Click on photo below to enlarge if needed...>>>
-
Thanks for the picture.I can see the numbers really good on yours.