G 22 universal slant top

[ALIDMAN]

Hi everyone  , so the machine worked fine then suddenly shows up with 2 codes , bill validator tilt and board monitor tilt , then the doors show only R and F close , and not matter what door is open , it will not change , i saw in one posting Rick said about board monitor tilt that IGT had recall on Molex 24 pin cable , that needs to be change , any input guys ?   

[rickhunter]

I recently had an issue with the door open/close not working for any door.  Turned out to be a PCI card.  I detailed the entire experience on a post.  The board monitor tilt is often the power cable as you say.  The bill validator may be related to both of the above, fix the others and then worry about the validator tilt.

[ALIDMAN]

thank you Rick , its so funny you test machine for 10 days , everyday for 8 hours a a day and nothing , then your friend drives for 5 hours each direction to get the machine and now this , i will change the card and see what happens  , tnx ALI

[rickhunter]

You might want to ask him to check on the grey ribbon cable to make sure it didn't get damaged or got loose during transport.  Also have him plug/unplug the atx power cable on both sides, that sometimes gets rid of the board monitor tilt issue.

[ALIDMAN]

Yes i did face time him and i checked those , they were good , it was just odd the doors would not show open or close as door open or close and these 2 issues , i get feeling i have 12 hour day coming up lol