New Life Games LLC
Bill Validators, Currency Acceptors and Printers => MEI Mars Bill Validators => Topic started by: Nepa Coin Op on September 04, 2018, 09:16:06 PM
-
Need a little input on wiring up an ae2600 serial to a pot o gold
Pog wires used for ba are labeled as
1340 Rdx from ba ————- to pin 11 ba
Ba send line ————- to pin 26 ba
Ba interrupt line ————-pin 8 ba
Bill lockout ——? ??? ??? ??
I don’t see a lockout on the ba pin out nor do is see
Where the low level signal ground would go ..... is that tied to the bill lockout on the board??? The rest are self explained
looks like it goes to low level ground on dba ... when hooked up like that the ba is activated but there a comm issue.... sucks the bill in but never finishes validation and stacks it.... anyone have the settings for the board using a serial mars setup ??
thanks
-
tag.