SuperStarsSpin

[scratchee35]

Just brought this into the shop...

"netplex down" as soon as i turned it on.

need to verify the software please

SB101122  sg000399   vs011gx1  dsv00058

thanks!!!

Steve

[sixcardmark]

Software is correct.

[scratchee35]

awesome....thanks!!!

Steve

[Slotcowboy]

Sixcardmark,
I have the same machine with the same software. I had all my limit settings and bill limit at 100,000 before I  had to replace my battery. Now my bill limit is 3,000 and it was 100,000. I  have tried the 3.1.4 option but can't change anything in it. I noticed my accounting denomination is at 0.10 and before I believe it was 0.01 could that be the problem? Some readings say you should be able to change the limits  in the 3.1.4. Any ideas.
Tom

[sixcardmark]

$3000 is as high as BV limit will go.  Default is $1000.  Do not enable coinless mode or limits will be locked.

[Retro tech repair]

How to diagnose a netplex link down error.

First disconnect all netplex drvices except the vfd.  This includes the bill acceptor, printer, some progressive displays, some top box bonus devices. Now that those are disconnected check the following.

Is your error solid or blinking.
Blinking
     Do you have a 50x or 1270 mpu?
     1270
          Remove the varta and u16.
      50x
          Mpu fault.
Solid
     Do you get no disp on your credit display
     No
          The mpu is not booting check the mpu for signs of faults or problems with the chips.
     Yes
          Check voltage at the vfd on the 2 pin connector
          Check the data cable for any signs of damage especially where the door closes.
          Mpu is faulty or damaged check for bent pins.