New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: drfreeze1739 on March 17, 2016, 06:06:00 PM
-
Hello
I have a JCM WBA-13-SS
It is in a IGT S + machine..
I get no power to wba at all. I have checked all the fuses
and all the connections on it and all seems to be good.
Dose not cycle at all when turned on..
i bought another power supply but they sent me a different on than i ordered.
the only difference i see between them both is that the original one is 13v 3a
the one i received is 13v 1.5a
would that make a difference in it not working?
-
OK.
Im getting red lights on the side of the WBA bill validator.
Found the dip switches all jacked up.. some on and some off.
so i put them all to the off side..
now it cycles when powered on..
dose any one know the dip switch settings...
-
Not 100% positive about an S Plus but on S2000 WBAs all dip switches are off for normal operation. Does your WBA have ID023 software? ID024 will not work.
-
It has the right software chip.. 022/023
i found some setting on the old NLG ..
yes all switches are up in the off settings.
it is now working ..
now i just need to get the lights to work on the front bezel..
i will switch the lights out if i have some to see if that works on that..
thank you RB for your info on this..
-
The light / acceptance does not work until you activate it with the Set Chip on the S+
Please see Ricks FAQs on this (Home page right side 1/2 way down).
-
It is all working...
i had to replace light bulbs...
-
It is 100% working now,,,,
it was dip switchs
it was bad bulb in the bezel..