New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM DBV-45, DBV-145, and DBV-200 Bill Validators => Topic started by: Badbaud on December 15, 2017, 03:51:54 PM
-
Does anyone know the manufacturer and part numbers for the 6 pin and 14 pin white connectors on the side of the IGT/Bally DBV200 head?
I need to purchase some to replace some corroded connectors.
-
Badbaud,
If you have not found the info yet. I believe the connectors are molex. If they are like the ones below they are marked MXJ 2 on the inside.
-
Ya, I contacted Molex and they said that series of connectors is obsolete and they don't have a cross that would work.
-
Hello,
a wire came off the connection that connects to the 14 pin connecter. would anyone know I can find out what slot the wire goes into? Or maybe a picture of yours?
thx,
Erbarr1
-
Not at the shop right now but it is usually the connection just vertical of the one connected.
-
Did the wire come off by itself? Or, did it pull out with the pin still connected? If you can, it might be best to post a photo and what game you have.
-
Ya, I contacted Molex and they said that series of connectors is obsolete and they don't have a cross that would work.
Maybe you or someone has a dead DBV head and you can take the connectors off it?
-
Ya, I'm still trying to find my solder pot after the move, I have about 10 boards I can rob from.
I was hoping for some new ones because those tin pins corrode down to the copper which oxidizes and causes a bad connection.