New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: JethroP on December 30, 2020, 06:57:37 PM
-
Have an IGT S+ that had a WBA-11. The WBA-11 quit working. I replaced it with a WBA-13 (including the required harness), but it doesn't work either. So guessing it's something beside the WBA unit. Neither one of these bill acceptors made any noise/cycling on power up. I have checked the WBA power supply and it measures 13 volts at both 13 volt outputs. Any suggestions?
-
Did you put the harness in correctly? if it'supside down, the power will be at the top and not the bottom!
Jim
-
The harness (connector) only connects one way. If it was upside-down they won't fit together.
-
Does the LEDs light up by the dip switch ?
-
Does the LEDs light up by the dip switch ?
I don't see any LED's anywhere.
-
Does the LEDs light up by the dip switch ?
I found them. They are not lit.
-
Try another PS.
-
Try another PS.
I would if I had one. I guess I'll have to buy one just to try.