New Life Games LLC

Bill Validators, Currency Acceptors and Printers => JCM WBA 10, 11, 12, 13, 14, 20, 21, 22, and 23 Bill Validators => Topic started by: Next_Gaming on November 11, 2018, 07:19:48 PM

Title: Question About Jcm Power Supply
Post by: Next_Gaming on November 11, 2018, 07:19:48 PM

Hi To All


i´m trying to repair an older power supply autec brand installed in PE+ however inside of the power supply i can see a little board whit 2 harness and photocoupler circuit this is burned same that the printed board, i am looking for schematics however  i can´t find anything about this board, i need that is possible and somebody can help to me to get this schematic or if exist another solution to replace this unit. Thanks for any reply about this issue.




Best Regards


Next

Title: Re: Question About Jcm Power Supply
Post by: Jim on November 11, 2018, 07:48:49 PM

Does this power supply run the WBA unit?   that small board may be the I/O  board, it has two optocouplers on it one for TX and one for RX.  it send the data to the cpu from the transport unit.

I have Phiong power supplies available, these were rebuilt and recapped  by me, also tested in a machine by me.

Jim

Title: Re: Question About Jcm Power Supply
Post by: Next_Gaming on November 11, 2018, 08:19:45 PM

Hi Jim


Thanks so much for reply, in efect this is the right board the power supply was repaired however this little board don´t, let me know prices of  you´re units.


Thanks Again


Best Regards


Next

Title: Re: Question About Jcm Power Supply
Post by: Jim on November 12, 2018, 07:21:08 AM

could you post a picture of the power supply and board, that would help a lot,  just to be sure we are talking about the same thing.

I'll post a picture of the unit tonight.

Jiml

Title: Re: Question About Jcm Power Supply
Post by: Jim on November 13, 2018, 08:16:42 AM

here is a picture of the I/O board inside this power supply.  and a picture of the power supply I have for sale.   Jim