New Life Games LLC
Bill Validators, Currency Acceptors and Printers => JCM DBV-45, DBV-145, and DBV-200 Bill Validators => Topic started by: NEWSLOTTER on March 14, 2015, 09:57:01 AM
-
the battery was replaced on this board recently and the bill taker goes thru its sounds when I turn the machine on. Red lights are on in bill chute. yellow lights on front do not light up. all wires are connected but I question a 4 hole connector plugged into the 14 prong male connecter on the left side of the bill taker. Is this correct and which 4 prongs should it be connected to? Help please
-
If you can post a picture that would be helpful, but most likely you just need to re-enable your bill validator using a set chip after the battery change.
-
PHOTO
-
Thanks tilt,
Had a heck of a time getting photo to post. My game now has a sp1271 game chip and a ss8170 reel prom. Where can I get a set chip and is that small plug on left correct?
-
Here's a picture of mine. It is a 14 pin connector with red & green wires (blue tracers) that goes over to the BV bezel lamp board. A couple of other wires join it there. Follow yours out and see if they go there as well. If so, then you can see what pins the wires should be on in the photo. Not sure why you would have a 4 pin connector on it though. Does the BV work (except for the light)? If so, you don't need to use a set chip, but if you want to pick one anyhow up try contacting one of the vendors at the top of the page. I'd try Blueridgeslots or Ohiogaming.
One other question. Did it work before you changed the battery?
-
great photo I now have mine plugged in just like yours but still no light on bezel, and yes it all worked before battery was replaced. thanks again!
-
Ok, you're probably going to need to use a set chip to re-enable it then.
-
Will this taker only except old bills and if so can I buy one that will take old and new bills?
-
The last released software for it V2.60 was for the new colored $10 bills. That version will accept everything except for colored $5 and the new $100 bills. JCM quit supporting the DBV-200 and the S+ platform. You may be able to find a WBA12 that will work with it and take the new $5s as well, but they were not in wide circulation. Blueridgeslots used to have some, you could check with him.
-
I ORDERED A CLEAR CHIP AND A SET CHIP WITH INSTRUCTIONS. THANKS TO ALL THAT HAS HELPED ME AND I WILL RETURN WHEN IT ARRIVES TO SHARE WHAT COMES OF IT. THANKS A MILLION!
-
Thanks for your help Tilt! Set chip got it working again. I have to get some more bills to try out. It took an 2006 twenty fine. I tried a 2006 ten but it spit it back out. :thank_you:
-
Great! Good job, glad you were able to get it working again. :applause: