New Life Games LLC

Progressive Controllers and Displays => Mikohn Progressive Systems => Topic started by: cdlale on April 15, 2015, 06:15:03 PM

Title: Early Mikohn Cham II+ Question.
Post by: cdlale on April 15, 2015, 06:15:03 PM

I picked up a early Cham II+ that has some of it's connectors mounted on its side. Also the controller board does not have U5 the flash memory chip. What is the difference to this board a later CHAM II+?
Thanks
cdlale

Title: Re: Early Mikohn Cham II+ Question.
Post by: UNIMAN on April 16, 2015, 05:34:07 PM

Post a picture of your board and I bet the experts will chime in.

Title: Re: Early Mikohn Cham II+ Question.
Post by: cdlale on April 16, 2015, 06:34:51 PM

Here's a pic of the board.

Title: Re: Early Mikohn Cham II+ Question.
Post by: qbert on April 16, 2015, 08:40:18 PM

Mikohn made changes to the flash memory so it would not bog down.
It is an early ChamII+  but should work OK.
 
Attached is the difference between a 2.05 and a 2.06

Title: Re: Early Mikohn Cham II+ Question.
Post by: cdlale on April 17, 2015, 12:44:11 PM

I have PSP ver 2.00, Do I use con 2 or Old?
thanks

Title: Re: Early Mikohn Cham II+ Question.
Post by: qbert on April 17, 2015, 03:27:23 PM

A chamII+ will work as a stand alone without the need for a controller like a con 1 or 2.
What machine are you trying to add a progressive to?
Rich

Title: Re: Early Mikohn Cham II+ Question.
Post by: BiggerHammer on April 17, 2015, 03:58:52 PM

For ver 2.00 select "OLD".

Title: Re: Early Mikohn Cham II+ Question.
Post by: cdlale on April 17, 2015, 04:12:50 PM

It's going on a  IGT PE+. I set the controller for SA (standalone). I am using the PSP settings listed on the other topic using a progressive on a PE+.