**Video Poker, Keno, Slots, 21** Gaming machines > **Video Gaming Machines** **General Chat**

3 card rack coin in timeout

(1/3) > >>

Badbaud:
Traced and Ohm'ed out the wires from the coin in switch to the board.

Door open / close circuit works.

Every coin in gives a coin in tilt.

Is there some other switch that needs to be activated to get a coin in to work without tilting?

Sunrise Side:
3 card rack - Bally V2000 ?


If so, coin switch defective?


I had a coin jam error that would come and go. Changed the coin switch and error is gone.


Also had the second/lower  switch that counts the coins going to the bucket under the stand, was out of adjustment causing a tilt each time.

Badbaud:
Changed the coin in switch twice, same problem, then connected a brand new pushbutton to the removed switch wires in case both switches were bad and same problem.

Bottom drop chute switch checks out good and ohms out to the board.

Checked all switch wires with a scope and no weird signals present, just 5V and ground where they should be.

Sunrise Side:
With the power off, can you take the rake out of play from the comparitor so the coins go through the "coin in" path and watch the coin passing by the trip wire on the coin switch to see if the wire is hanging up and being delayed at any point? You can also stop the coin at the point where the coin meets the trip wire an let it down through the channel slowly by hand too see how the coin flows through the channel and reacts with the switch. If the trip wire binds or drags at any point, it seems to only takes a few milliseconds delay to cause the tilt.

Badbaud:
No binding, this is some kind of machine side related problem because 3 different working racks do the same thing.

Holding the coin switch in my hand and flicking the wire produces the same tilt.

On our 3 card rack tester the error does not occur, all 3 racks work perfectly.

Navigation

[0] Message Index

[#] Next page