**Reel Slots** Gaming Machines > Bally Reel Games
How to perform a SafeRam Clear on a Bally S6000
rokgpsman:
Post photo of shunt block. Something doesn't sound right.
dcardman:
ok, i will take some right now
dcardman:
Also this is what comes up when I turn it on. The lights flash
Badbaud:
You will need to replace the shunt with a 8 position DIP switch. Turn all switches off. Then turn switch 8 on.
Hold the two buttons in and turn the machine on.
Watch for CHC then CLC then turn the machine off.
Turn DIP switch 8 off and turn on the machine.
Do not close the door until the reels have done their bump dance.
When the reels are done you may see a 50 code on the display, if not you will see a day/month/year setup. Just press the change button to exit that setup.
Close the door and the game should be ready to play.
Mr. Dinoman:
You definetly have a S6000...Ram clear is very simple...See attached doc...also here is a small test to see if your New stay in mains are working...
Bally s5500 and s6000 stay in mains….
Leave you original chips in your MPU board...Turn off the power and pull out the MPU board...
Turn on Dip Sw1 # 8
Put the MPU board back in...
Press and HOLD the PSEUDO COIN and TEST buttons...
You should see CH C followed by CL C...(If you do, then you have what they call "Stay in Mains"
Turn off the power and set the Dip Sw1 # 8 to the off position...
Replace the MPU and power back on...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Cell Phone and Pad Mode imode wap wap2 |
NLG Archives Archives @ newlifegames.net Wayback Machine |
Contact Us NLG Shop 928 754-4147 Email Us 1788 Highway 95 30 BHC City AZ 86442 |