General NLG Chat > Before and After Restoration Pics

S+ to S2000 Conversion Project

<< < (2/7) > >>

Stayouttadabunker:
Now is a good time to slide in an MPU tray to keep out anything that might fall into there such as screws, nuts or washers. :yes:

The MPU cage is slightly loose at this point because the reel shelf isn't yet attached to it which will make the whole unit more stable and stiff.

Tomorrow we will install a reel tray to be perfectly aligned up with the center payline of a reel glass. :cool_thumb_up:

Stayouttadabunker:
okay...we need to do a couple of things before we can add an S2000 reel shelf to this cabinet.


First  :Professor: we have to install the WBA cage to the inside right wall of the cabinet.

These WBA cages have that single bolt hole that attaches to the shelf - which will help in assisting us later as an "extra hand".


5 nuts secures it to the cabinet standoffs using a 7mm socket with an extension.

There's 3 vertical holes and 2 horizontal lugs under the cage itself.

You can remove the little cherry switch on this cage on the bottom right...it's not needed for home use.


A small 5mm socket takes care of the pair of nuts holding it, if you want or......


You can take your electric hand grinder and remove it right off the cage if you wish.  :rotfl:


We're never  :no: going to use that little PITA cashbox door switch again ever!   :Tongue_Out:

Stayouttadabunker:
I must add...the picture above should be the next step.... :duh:


The bottom guide rail plate in the cash box cage needs to come off so the WBA cash boxes can fit in.

To remove, I secured the cage in a vise, and drilled out the four spot welds with a 13/64" high speed drill bit...

then you can do the step in the above Reply... :cool_thumb_up:


Wear goggles when doing any drilling or cutting or grinding!
You only have ONE set of eyes!

Stayouttadabunker:
okay...once you have the cage attached to the wall, you need to put in the transport unit of the WBA.


You sort of drop it in near the top of the cage and slip it onto two small metal lugs on the floor of the cage.


There are two small screws that need to go into the rear of the cage to secure the transport guide.


For this, I recommend a long magnetic screwdriver!


Click on photo to enlarge to see how far in the back those two little suckers need to go in!...>>>

Stayouttadabunker:
Now you can slide in the WBA and it's respective metal cash box to see how it all fits.  :sherlock:

Later on when we install the harnesses, we will slide back out the WBA and install the beau plug wires & housing the bill acceptor connects to.

Navigation

[0] Message Index

[#] Next page

[*] Previous page