Bill Validators, Currency Acceptors and Printers > JCM DBV-45, DBV-145, and DBV-200 Bill Validators
Bill Validator cycling
(1/1)
jay:
Hi all,
I just moved to a new home and am in the process of rebuilding my basement casino.
So far I have torn out all the carpet, laid down the vinyl plank flooring and the place is starting to take shape.
The machines (3 S+ and a PE+) are all back on stands, fire up fine.
SO... I am busy on the other side of the room (building the bar) and my PE+ just stared cycling the bill validator (DBV200) - similar noise to that of the machine turning on. I went over turned the machine off / on. Came on and about 3-4 min later it started this again. I reseated the cash can and once again it started the cycling. I reseated the head, again it started the cycling.
I eventually pulled the small square connector at the base of the head and its quiet.
Other than the move josling the bits about - I am not sure what else would cause this.
Given that I am in Canada and the DBV is USD based this is an adequate fix for now but am looking for what might be the root cause.
sixcardmark:
I think that connector you unplugged is the common problem. Try wiggling it around and see if it turns on and off.
jay:
Thanks - I will play with it and report back.
Navigation
[0] Message Index
Cell Phone and Pad Mode imode wap wap2 |
NLG Archives Archives @ newlifegames.net Wayback Machine |
Contact Us NLG Shop 928 754-4147 Email Us 1788 Highway 95 30 BHC City AZ 86442 |