New Life Games LLC
Monitor Repair Log and Database. **Arcade and Gaming** => LCD and CRT Monitor Repair Tech Support => Topic started by: DLacey on March 11, 2023, 12:33:40 PM
-
I changed out the original CRT in a 17" igame for a used Ceronix (small plug), the calibration is way off on the new to me LCD, turn key twice to get into calibration page and it will only allow me to touch the x in bottom left corner? after touching the x in bottom left corner it goes to "turn key to exit" calibration remains way off to the point where a touch button on the left side of the screen is someplace over on the right side with touch. even tried clearing the machine with key chip. replaced with old CRT and calibration works perfectly. only replacing to upgrade screen, CRT stil works fine. person i bought the ceronix lcd from sent me a touch screen board to replace on ceronix lcd but it still works the same... im hoping this is solvable without having to ship it back?
thanks for the help and comments
Dave
-
Did you try using the monitors OSD buttons located on the top of monitor? Second button from left is auto adjust.
-
If swapping the touch screen control board didn't change the condition then the touch screen glass, panel, mask whatever you like to call it is most likely bad