New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => IGT PE and PE Plus Poker Games => Topic started by: pughpoker on March 02, 2022, 01:56:31 PM
-
HELLO I RECEIVED THE PE+ CLEAR AND SET CHIPS AND I DID THE WHOLE TAKING OUT MY PE+ GAME/PROGRAM CHIP OUT OF MY MPU IN MY MULTI GAME POKER SLOT MACHINE IGT. GOT TO THE SCREEN WHILE THE CLEAR CHIP WAS IN THE PROGRAM SPOT ON MPU BOARD AND A MESSAGE CAME UP SAYING TO HIT THE RESET SWITCH (IM GUESSING IS THE WHITE BUTTON ON LEFT SIDE OF THE METAL BRACKET THAT HOLDS THE MPU BOARD) I HIT THAT THEN REPLACE THE CLEAR CHIP WITH MY GAMING CHIP AND THATS WHEN I HAVE TRIED EVERY SEQUENCE OF HOLDING RESET BUTTON FOR 5 SECONDS AND THEN CLOSING THE DOOR AND TURNING THE JACKPOT RESET AND THEN GET A FEW DIFFERENT MESSAGES DEPENDING ON WHAT SEQUENCE I DO IT NEVER ALLOWS ME TO GO THROUGH A SETUP IT DOES ALLOW ME TO SEE THE INPUTS AND OUTPUTS AND I CAN CHANGE DENOMINATIONS AS WELL AT SOME POINT IT ASKS ME TO ENTER A WAM ADDRESS... I HAVE A ULTI GAME POKER MACHINE PE+ IT DOES NOT RECEIVE BILLS JUST COIN HOPPER. IS THERE ANYONE ON HERE THAT CAN WALK ME THROUGH THE STEPS AND I BELIEVE I GOT A LITTLE ANGRY AT THE DAMN DOOR AND I MIGHT OF DISCONNECTED THE DOOR SENSOR WIRES NOW ON THE SIDE BY THE MONITOR WHICH I THINK I WILL SPLICE EXTRA WIRE TO BYPASS THAT DOOR SENSOR AND IM HOPING THATS NOT MY PROBLEM FROM THE BEGINNING. I DO GET TO CALL ATTENDANT CMOS AND ALSO A EEPROM DATA FAILURE OR EEPROM DATA. ANY HELP WOULD BE APPRECIATED
-
The reset switch it was referring to is the jackpot reset switch on the side of the cabinet, but it really doesn't matter right now. Why were you trying to accomplish by clearing it? It's not normally required.
If you're not using a bill validator there's no need to use a set chip. The set chip is used to enable the bill validator and set the machine denomination. The denomination is only required so the machine knows how many credits to give you for the bill you put in it.
It's not clear to me what you did to the optic wires, but I would connect them the way they should be before trying to bypass them. Post a picture.
Here's a document that may be helpful getting the machine initialized, but you have to repair the optics first.
-
Pour ma part j ai supprimer les optiques de porte en reliant les 2+ ensemble et les 2- ensemble et un interupteur qui coupe le + pour la porte ouverte cela fonctionne chez moi
For my part I removed the door optics by connecting the 2+ together and the 2- together and a switch that cuts the + for the open door it works for me