New Life Games LLC

**Reel Slots** Gaming Machines => Bally Reel Games => Topic started by: BALLIGATOR on June 15, 2014, 11:32:33 AM

Title: Bally 6000 handle question
Post by: BALLIGATOR on June 15, 2014, 11:32:33 AM

Hi,


I bought an S 6000 which was manufactured without a handle. There was no hole, nothing inside but the cable that goes to the assembly when there is one.


I installed a handle but there is no click when i insert a coin.


My question is: are the programs on the cpu different when there is no handle, which I doubt?


Thanks

Title: Re: Bally 6000 handle question
Post by: LINDAM on June 15, 2014, 11:51:17 AM

It sounds like you might be missing a voltage. check the cable you've plugged in to see if it alive.

Title: Re: Bally 6000 handle question
Post by: BALLIGATOR on June 15, 2014, 12:53:09 PM

Thanks for the reply.


Actually, there is no click when a coin is put in.

Title: Re: Bally 6000 handle question
Post by: LINDAM on June 15, 2014, 01:37:30 PM

Then How do you know you have power on the handle solenoid? Does the coin go to the hopper or pass through the machine?

Title: Re: Bally 6000 handle question
Post by: BALLIGATOR on June 15, 2014, 02:56:40 PM

The coins are registered and I can play normally except there is no click  and as a consequence I cannot use the handle.

Title: Re: Bally 6000 handle question
Post by: LINDAM on June 15, 2014, 04:26:11 PM

You do know, you must use the "Bet One" button to use the handle.

Title: Re: Bally 6000 handle question
Post by: BALLIGATOR on June 16, 2014, 01:51:36 AM

Sure, but there is no click.

Title: Re: Bally 6000 handle question
Post by: cowboygames on June 16, 2014, 05:42:04 AM

When you hooked the handle up were there two plugs? One for the solenoid and one for the micro switch that starts the reels spinning when the handle presses it? I'm relying on what I know from IGT machines and assuming Bally uses a similar setup