New Life Games LLC

**Video Poker, Keno, Slots, 21** Gaming machines => IGT PE and PE Plus Poker Games => Topic started by: chasec1986 on July 06, 2022, 08:43:10 PM

Title: DOOR OPEN cmos data error
Post by: chasec1986 on July 06, 2022, 08:43:10 PM

I have an IGT PE+ upright machine that I have replaced the battery on and now get the cmos data error and open door error. All of my doors are operational and I can verify they work on another superboard that I can access the test screen on. Is there anything else on my machine that would throw a door open error? All I want to do is reset the cmos data error but cannot move forward due to the door open error.

Title: Re: DOOR OPEN cmos data error
Post by: Z71OFFROAD on July 07, 2022, 05:43:26 AM

 Press and HOLD the white "Self Test" button for about five seconds.  If the speaker is working you should hear a small "ding".  Close the door (again, the "door open" message should and needs to go away), turn the jackpot reset key, and you will either be good to go or get another error (EEPROM something or other).  If that happens, open the door again, press and release the self test button, and close the door -- you should be in business.

Title: Re: DOOR OPEN cmos data error
Post by: chasec1986 on July 07, 2022, 10:42:30 AM

Hey offroad I cannot complete these steps as the door open message never goes away. My optics work and my cherry switches work. I have a belly door and a BV door. Besides the main door are there any other door locations I may be missing? Attached is the schematic on how my candles are blinking.

Title: Re: DOOR OPEN cmos data error
Post by: jay on July 07, 2022, 10:57:58 AM

If another superboard in your PE+ is working then its not physical.

I would first check all of your chips on the suspect mother board.
It sounds very much like you have 'a' chip with one leg bent under or not seated right.
Probably more on the program and data chips than the graphics ones.

Failing that I would run a clear chip through your machine.

Title: Re: DOOR OPEN cmos data error
Post by: chasec1986 on July 07, 2022, 02:59:59 PM

Well of the chips are installed correctl and no bent pins. Ran a clear chip and there door open error is still on the screen. Super frustrating!

Title: Re: DOOR OPEN cmos data error
Post by: sixcardmark on July 07, 2022, 03:06:24 PM

You say your door optics are working.  Are they lined up?

Title: Re: DOOR OPEN cmos data error
Post by: chasec1986 on July 07, 2022, 04:10:22 PM

Hey Mark yes they are lined up. On my other board in the test screen it flashes from 0-1 rapidly. From what I've read on other post that means they are functioning properly. Correct?

Title: Re: DOOR OPEN cmos data error
Post by: mantaramian on August 22, 2022, 10:40:43 AM

Were you able to get the issue resolved? I had a similar problem last night. I found one of the pins on my Wingboard was the culprit.