Red White Blue 7's quarte machine not working

[slot newbie]

Hi.  I tried the instructions and again nothing.  Just lights up.  I attached a picture of the CPU board

[RobinAK]

Have you tried holding down the test button for 3 seconds or so?

[jonbbrew]

Have you tried holding down the test button for 3 seconds or so?

I know i did and nothing for me....

[slot newbie]

Holding the test button did not do anything. 

[Tilt]

Hi.  I tried the instructions and again nothing.  Just lights up.  I attached a picture of the CPU board

Nothing in the picture jumps out at me.  My suggestion would be to either replace the MPU board or have it checked out.  S slot MPUs aren't quite as available as S+ ones and they're not interchangeable.  Check with Alan (Badbaud) and see if he can test/repair it for you. 

[slot newbie]

Thank you I reached out to him.  Hoping something can be done.

[jonbbrew]

Thank you I reached out to him.  Hoping something can be done.

get it working?

[slot newbie]

I sent to Allen.  He was able to repair it.  I is being shipped back.  Should be here Tuesday.  Looking forward to getting this machine running again.  One of my dad's favorites.

[jonbbrew]

I sent to Allen.  He was able to repair it.  I is being shipped back.  Should be here Tuesday.  Looking forward to getting this machine running again.  One of my dad's favorites.

So did he say the board was faulty? My boards work in other machines, so i am stumped.

[slot newbie]

There were issues with the board that he repaired.  The board worked K-Lar's shop.  Unfortunately the machine still does not work.  Alan was so nice to give me the contact information to someone in PA that is closer to my location  that will maybe be able to assist us with a possible wiring issue.  I will give you an update when I have one.  I do appreciate all of K-Lar's assistance on the phone and working on my board. 

[jonbbrew]

Good evening I am attaching a picture of the only place that we have switches that I can find.  No clue why it is not working.

With the power on, loosen one at a time, each of the fuse holders and see and listen for any changes. You should hear speaker crackle, you can see lights come on/off but you should also ear different hums. Check that each fuse has some sort of change in the machine.

Also, is your candles showing anything?
Did you run optic tests or switch out optics?

Need to figure out if your machine is recognizing the main door being closed.