New Life Games LLC
**Reel Slots** Gaming Machines => WMS Reel Games => Topic started by: mguistolise on February 25, 2022, 11:46:12 AM
-
I have a WMS reel Double Easy Monet slot that has been in storage for 5 years. Working fine when stored. Now it will not boot all the way up. Was getting a battery error. Change both Cr2032. Not just stops booting half way in. I have attached a image of where the machine stops loading. Can any one help?
Mike
-
Whenever you replace batteries, you have to perform a clear and setup the game again.
-
Now I restarted the game to run the clear chip, but the small screen will not go on. Says no signal, then goes black.
Mike
-
something is probably loose. Check to make sure all your power leds are lit on the backplane (upper right hand side, there is a series of green leds labeled with voltages they correspond, they should all be lit green). Make sure the mpu is all the way down. The clear card goes in the OS Slot.
-
Bottom screen was working fine. The reels now just keep spinning slowly as always during start up. But that black screen just says "no signal" for a few sec during start up. Then goes black. I checked all cables over and over. Cannot do a clear with out that screen. Anyone have any ideas??
Mike
-
I would lift and re-seat the mpu to make sure it didn't come loose.