Dt-104 pinout

[Cve730]

I found a jcm dt-104 programmer that is missing the cable that attaches the validator to the programmer and the power supply. Can someone with a dt-104 share a pic of the pinout of the communication cable and the power supply requirements with me please? 
i have some wba 12 units i would like to get up and running
Thanks

[Sunrise Side]

You will need a 12 volt switching power supply like used on a laptop. you will need the connectors that plug into the power and comm ports on the  DT-104. You will need a connector that connects to the back of the WBA . I will post pictures of the wiring later today.

[Cve730]

Thanks for the reply i appreciate it, i have a harness i believe to be for the older wba 10 version. i want to try and rewire with a wba 12 end and use that.

[Badbaud]

Here is a picture of all of the cables I use on our DT104.

[Cve730]

Thanks for the reply, i think the 2 harnesses on the top left of the pic is what im looking for. Anychance u could post a close up pic of the ends of those two so i could try and copy them?

[Badbaud]

Email me and ask for those pictures.

[Sunrise Side]

Harness for DT-104/DT-004 to WBA

[Cve730]

Thanks for the pics it looks like some of the wires change color by where your tag that says "single wba" anychance i can get one more pic of that are? Thanks I appreciate the help

[Sunrise Side]

The only change is the white wire is connected to the yellow wire because I used parts and pieces of harnesses because I do not know what the plastic connectors are called, I don't know what the wire connectors are called, and I don't have the tools to work with to make all these connectors.  The twisted black and red wires are the 12V and are the bottom 2 Black and Red wires in this picture of the WBA connector.  The Green, Yellow, Orange, Red, Brown are the comm wires.

[Cve730]

Thank you i got it wired up and its working, now i can start going thru some of these wba's. I appreciate the help