New Life Games LLC
**Reel Slots** Gaming Machines => IGT S and S-plus Reel Games => Topic started by: gmtransman on February 22, 2017, 02:12:05 PM
-
i would like instructions to take my old jcm 200 out and put a new wba 11 or 12 in . problems i found
(1) bill bezel is a 1/8 to wide, do i need different bezel or modify what i have
(2) bill bucket will not fit, do i need new or cut off the old rails at the bottom that are in the way
(3)i have two wires that go to the front door, what do i do with them
(4) i have the silver power supply for the wba 11 for the s plus machine do i use all four connections
any help would be great , thanks.
-
Your decision will depend on which validator you want to use. The 10/11 is the normal B/V for an S+. The 12/13 is for the S2000. I would suggest an 11 or 13. These 2 are eprom units and the 10 and 12 are a flashed chip unit. I use an 11 and just keep the older non colored money around to use in it. The 13 will use some of the newer money but not near all in the S+. That being said, some of our vendors on here have all the parts you need to switch it over. Don't try to modify parts it probably won't work and the parts are easily available. The power supply for the WBA will work fine. The 2 wires that go to the cash can door, strip the ends tie and tape or wire nut together. The stacker cage for the DBV is different than the WBA I'm pretty sure. But it will come with the "kit". You can use the 12 or 13 but you need a specific software to make it work in an S+. It's not a difficult job, but it is parts specific.
Dave