New Life Games LLC
Arcade Games, Pinball, Crane Games, Redemption Games and Other Stuff => Arcade Games **Video** => Topic started by: Ryengoth on July 08, 2018, 11:52:20 AM
-
Williams Joust/Robotron cabinet with a Jamma 60-n-1 board installed. Joysticks are Wico and based on the fossilized grommets there were original. Replaced the grommets while it was apart.
CRT failed (flyback was dead when I pulled it) and owner wanted an LCD swap.Going to try to repair this Eygo display with a universal neck and main board and resell it. Have not had time to check the coil resistances. Did not see much burn-in when I was checking it out.Having an ATX power supply and a monitor with a 3-prong power cord made it interesting for power re-wiring. I ran a Stanley 9ft H/D power cord to a GFCI outlet and box. It's good to have a receptacle in the cabinet for servicing so you don't have to hunt for power.
No video on this one. It was a quick turn-around. I do have some short phone video segments of the display operation and Wico joystick repair that I may put together.
(https://i.imgur.com/OTFXgpm.jpg)(https://i.imgur.com/Q0BUJmQ.jpg)(https://i.imgur.com/WC51ZCh.jpg)(https://i.imgur.com/GN5n3iH.jpg)(https://i.imgur.com/SuzghoA.jpg)(https://i.imgur.com/5E37e4j.jpg)(https://i.imgur.com/I9CF4Rm.jpg)(https://i.imgur.com/wnt4ZR9.jpg)(https://i.imgur.com/h5RxULe.jpg)(https://i.imgur.com/ETBP1yW.jpg)(https://i.imgur.com/0B0kDt1.jpg)
(https://i.imgur.com/nW2Lp83.jpg)(https://i.imgur.com/vE1Ceru.jpg)