New Life Games LLC
**Video Poker, Keno, Slots, 21** Gaming machines => Bally Alpha (Cinevision), and ALL Bally "V___" series - V5000, V2000, V1000, etc. => Topic started by: coolwavepic on November 26, 2019, 04:52:25 PM
-
Does anyone have any documentation from Bally on how to properly replace the monitors on both 22/22 and V32? I never wanted to tackle this but was looking at it the other night and want to make sure I am doing it correctly. If no documents are to be had, what is your experience with both cabinets?
Thanks for any input!
Happy Thanksgiving everyone!
-
PRO 22/22 Bottom: 2 Phillips screws at the bottom and tilt out (Top of the monitor is held in with pins/studs)
PRO 22/22 Top: Open speaker door, lift out upper monitor chrome trim piece, lift monitor UP, then out. Swap out brackets from old monitor to new.
PRO 32: 2 screws at the bottom. Monitor is held in with 4 "hooks" that go into the Yellow Frame.
Very easy on the 22/22. The PRO 32 is a Bear because the monitor is so big and heavy!! You must be VERY careful not to damage the touchscreen once you unhook the monitor from the frame to get it removed from the machine. NOTE: The PRO32 only accepts ONE type of monitor!! If you're thinking of installing an older A1 V32 (or Hammerhead 32 monitor) into a PRO32 cabinet, you'll be cussing and cutting and fabricating. Best just to break down and spend $900 on a new Ceronix that was designed to go into that cabinet.... In my opinion.
Hope this helps!
-
Thank you for your input. With the 22/22 does the speaker need to be removed before taking out the monitor? When looking at it I figure it was just 2 screws and the way its "wedged" in there looked like it would slide out but it is up against the speaker. Just wanted to make sure before I try it.
-
You do not have to remove the speakers. Easy job.