Bezel for future logic Gen. 2 printer ?

[KAD]

I want to put a future logic printer in my S2000 . Does the bezel have to be specific to the printer and the machine. Is there a lighted one? Thanks, KAD

[dailey]

First, I would need to know the mounting location of the printer. There is a bezel for the top box mounting and a different bezel for the reel shelf mount. Light boards are available for both.

[KAD]

Thanks, It's a side mount, I have found printer and mount but unsure what bezel I need. KAD

[KAD]

So which ones on that pic work on an upright S2000? Thanks

[dailey]

For the side mount Gen2 printer you need the Long Bezel 130-00021-100 and the light board with the mounting bracket 607-828-01, plus mounting screws for both.

Note that the light bracket mounts to the face of the printer below the bezel and plugs in to the connector on the face of printer.

[KAD]

Thanks, that's exactly the info I was looking for. 

[RB]

For the side mount Gen2 printer you need the Long Bezel 130-00021-100 and the light board with the mounting bracket 607-828-01, plus mounting screws for both.

Note that the light bracket mounts to the face of the printer below the bezel and plugs in to the connector on the face of printer.

That is NOT the correct bezel light assy pictured for a Gen 2 regardless of what spin says. It will attach but not connect. Gen 2 uses a 3 wire micro fit connector.

[KAD]

Thanks RB , I'll see what I can find. KAD

[RB]

The two wire light board will probably work if you change the pins and connector. I am thinking they added the additional chassis ground because the gen 2 printers were made of plastic rather than steel. It is probably not a necessity.