S2000 can't get printer to print voucher after Clear & Key

[Archilea]

After a C&K, and setting the options as above except for:
- 7.1.1.2 Coin Denomination $0.25
- 7.1.7.1 Token Setup: Token Value 001
- 7.1.7.2 Token Payout: Partial Token Cashout Disabled
 
Hopper Limit: 00000
Credit Limit: 200,000
Jackpot Limit: 200,000
Bill Limit: 10,000

3.4.1.1.4 Primary Hand Pay: Single Report (Only choices were Single or Multiple report, no Disabled option)


Sadly, the results are the same. Cash Out does not print a ticket (With 800 credits), and I get the "Call Attendant" and an alarm bell.

Meter shows 4.93 volts on the TITO board, coming from the red & black wires off of the top of the power distribution block shown in the photo.  That panel says "WAP EZPAY" if that makes a difference.

[Archilea]

Photo attached.

The TITO instructions said:

Plug the 3 pin plug into the small plug on the side of  the communication board next to the 2 pin connector. This will supply power to your board. The connection is always on, so I suggest connecting the machine to a power strip and turning off the machine at the power strip when not in use to make sure the board is not on 24 hours a day when not in use.

Connect the 5 pin connection to the front of the communication board to the 5 pin plug.

Someone please verify my connections in the photo, for sanity's sake.

[RB]

Is there a ribbon cable connecting the comm card to the motherboard? Your pic only shows part of the distribution box.

[Archilea]

Is there a ribbon cable connecting the comm card to the motherboard? Your pic only shows part of the distribution box.

Yes. Full photo attached...

[Archilea]

After further inspection, the OTHER end of the cable was not fully plugged into the connector.  Once fully seated, it now works and gives me credits when the service button is pushed. Vouchers print out and are read back in correctly.

Thank you for your help.